Plywood and tubing helps turn the 90 degree corner inside the armrests. To hold the conduit I used nails and a scrap peace of wood.

Glassing the yaw conduits.

In this picture you can see how the conduits works and the spring connection. Take your time with the cabling and springs making sure you get full travel. I had to trim the tubing by 1/4 inch to get full yaw cycle.

Here is the play wood hard point mount for the yaw control. Used a peace of scrap foam as a wedge to hold till cure, then glassed over it.

Mounted the yaw control, purchased the control handle and other metal parts from Cozy Girls their workmanship is very good.

Yaw control system complete.

View of the Yaw control as it goes through the front seat supports.

As for the pitch, I am thinking about installing the  Strong Electric Pitch Trim most likely the way I will go.

More to come almost finish, not sure about the pitch controls.