Chapter 11 - Step 2

This step involves applying fiberglass to the bottom of the elevators.

Elevator Cores September 22, 2001. Here is an elevator core after sanding the cores to contour around the torque tubes. The next step is to apply glass to the bottom.

Bottom Glassed October 21, 2001. Here is one of the elevators after applying two layers of UNI to the bottom. The black "V" is actually marks on the UNI, one per layer, that happend to line up this way. I made good use of the squeegee and a hair dryer to get as much epoxy off as I could. It was barely 70° in my workshop so the hair dryer was a must.