Chapter 16 - Step 1

This step has you create the pivot blocks.

October 12, 2003. No picture of the bearing blocks CS-109 and CS-118. The only thing different from the plans is the location of the holes for the bearing. If you use the FMN10 bearings instead of the original phenolic. Just use one of the FMN10 bearings as a guide for the hole locations and keep in mind they are 1/4" holes, not #12 holes.

Dimpled CS-123 bearings October 20, 2003. I used the drill press to make some dimples around the bronze CS-123 bushings.